Towns & Kingdoms — Beyond the ForgeHandbook

Build guides

Create power and machine troubleshooting

Get a stopped workshop turning again and find out why a spinning machine still refuses to process an item.

What you need

Set it up

  1. Find where rotation stops

    Check that water flows past the paddles of the Water Wheel. Disconnect the machine, then follow the shaft line from the water wheel outward. Check the axle direction of each shaft. Use a Gearbox to turn a corner and make sure cogwheels mesh.

  2. Fix an overstressed network

    Wear Engineer’s Goggles and look at a Stressometer or a kinetic block to inspect the network. If demand exceeds the available stress capacity, remove a load or connect more power at compatible speed and direction. Speeding up a loaded branch generally increases the stress it uses.

  3. Check the machine and process

    In JEI, hover the output and press R to check the exact recipe. A Mechanical Press needs an item under it on a Depot or belt, or in a Basin for compacting. For a Mechanical Mixer, mesh a vertical Cogwheel beside the mixer’s upper cog. Place the Basin two blocks below the mixer with an air block between them. In this pack the mixer needs at least 30 RPM. Aim for 32 RPM by stepping up an 8 RPM Water Wheel twice with large-to-small cog pairs. Put a lit Blaze Burner below the Basin if the recipe calls for heat.

    An 8 RPM Water Wheel drives two size-changing cogwheel pairs for 32 RPM. A vertical cog meshes with the mixer’s upper cog from the side. The Basin sits two blocks below the mixer.
  4. Return incomplete items to the start

    Read every operation and the loop count in JEI. Feed the base item through the listed stages in order. Route the incomplete item back through the line for the remaining loops. Filter the completed item out so it goes into storage.

Troubleshooting

Two spinning lines won’t join
Check both speed and direction before connecting them. An incompatible kinetic connection can break a block. Prove the direction on a short shaft before you reconnect the machines.
The belt won’t attach
Use the Belt Connector on two parallel shafts. Check alignment and clear the path between them. The pack offers a dried-kelp recipe and a rubber recipe for connectors.
The machine runs once and stops
Check for a full destination or a blocked output funnel. Prove the item transfers with one input and storage with a free slot before running a batch.

Find a weapon, ingredient, mod, chapter or skill.